I am wanting to start reloading for my M48 Yugo Mauser. I have the Lee 175gr gas check mold and wondered if anyone had any load data. I am looking more for accuracy than velocity.
I am wanting to start reloading for my M48 Yugo Mauser. I have the Lee 175gr gas check mold and wondered if anyone had any load data. I am looking more for accuracy than velocity.
Welcome to the Guide, Victor.
Good mould. I have had pretty good accuracy with it.
This formula will work with Extruded (IMR) and Flake (Alliant) powders. NEVER use it with ball powders.
Jacketed Max - Jacketed Start = Difference
Jacketed Start - Difference = Cast Start
I work up from Start in full grain increments. I have had best luck with IMR 4895, 3031, and RL7.
For strictly target loads, many have good luck with Alliant pistol powders. PM me an email address if you want more data and I will send you a Word .doc of an article by C.E. Harris that has a lot of good info. I have posted it here before, but can't remember when/where or I would post the link.
Accuracy is up to your rifle.
"Stand your ground.
Do not fire unless fired upon.
But if they mean to have a war let it begin here."
- Capt. Parker, Lexington Militia, April 19, 1775
start at bout 25 grs of the 4895.
the lyman cast bullet book has good data.
Thanks- I'll try that
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |