tackstrp
02-09-2011, 02:33 AM
I found that I was seating the bullet to far down. Was looking at a Winchester 9mm commerial FMJ and relized that some of the feeding problems i was having was over all length was to short.
The excess Alox or xlox at thinned to 60 % mineral sprits helps, but still need to wipe excess off . I like shiny and bright exposed lead. To make over all length longer had to bring out one micro lube groove . could do two grooves, which i wil try.
Anyway, ordered the 356-120-TC, will use my lyman 450 with Lyman orange magic.
Reason i used the orange magic is the heat range is within the heating range for the lyman add on heater. Tried the heat air gun, heat lamps. and did not care for results.
If it gets to hot can add a rheostat.
will see what happens.
i know 100 different ways to do this so i did not subsribe, just sharing
The excess Alox or xlox at thinned to 60 % mineral sprits helps, but still need to wipe excess off . I like shiny and bright exposed lead. To make over all length longer had to bring out one micro lube groove . could do two grooves, which i wil try.
Anyway, ordered the 356-120-TC, will use my lyman 450 with Lyman orange magic.
Reason i used the orange magic is the heat range is within the heating range for the lyman add on heater. Tried the heat air gun, heat lamps. and did not care for results.
If it gets to hot can add a rheostat.
will see what happens.
i know 100 different ways to do this so i did not subsribe, just sharing