View Full Version : saeco lubrisizer

04-06-2009, 09:58 PM
I have just purchased a used saeco lubrisizer. This is an oldie from Cal. I need to know how to take off the old sizing die that is on their. Thanks

04-06-2009, 10:18 PM
Welcome Hoop.

I believe that model is now made by Star. I'm not much help though as I push-through size everything. I would check next door at CB if you don't get a good answer here.

04-06-2009, 10:26 PM
I e-mailed Redding and they said their punches and dies will fit. They sent me a one page instruction booklet, but didn't help. Thanks

04-07-2009, 02:43 AM
the star is made by magma engineering now.
i think the saeco is more a redding type.
is there a set screw?
have you tried to heat it up? sometimes the old lube gets really hard and acts like cement.
i have even heard of guys putting them in the oven on a cookie sheet at low temp 125-150 for an hour or two.
a heat gun could do the trick,or boiling it.
some ideas anyways.

04-08-2009, 01:18 AM
Thanks, all this helped, using my wife's hair dryer did the trick.