Hello,
I made 7 reloads to test a few powder amounts.
Did not clean the cases, they were shot once.
Did not lube them (this stuff will be done from now on now that iv got started)
Cast bullet with lee 9mm. not the tumble lube kind, but i tumble lubed. iv now bought a tumble lube type mold.
dillon square deal b press, all factory settings.
They all shot fine once chambered, the lower loads did not have as much of a kick as i would like, but the gun itself cycled just fine, also they would not go in with me racking the slide, so its not likely a powder issue.
of the 7, 3 or 4 would not chamber. one i had given up on till i noticed a bit of lead building up around the rim of the case, i took an empty case, scratched off a sliver of lead around the rim of the case, and i was able to camber it.
any ideas?