Search:

Iv got an issue with my powder funnel gouging up and gripping cases while not flaring them well (just some, not all, apparently). so i would like to lube them. is there a lube i can mix with polish...

I have a dillon square deal b. the part that it seems to get stuck on is when it opens the case neck and pours in powder. commbing back down off of the die is where it gets stuck. i should get ahold...

yea, it works fine otherwise.

i ran some loads at the same 6 gn, without lubing the cases, and they ran fine. i think i'm just getting lube in the case mouth which is causing it to not work.

Well. lube seems to be it. I ran some non lubed cases today, they worked perfectly. did feel rough running them through the press tho. so i need to find a different solution for lubing

Thanks. Can you give me any advice on cleaning the extractor? Its a right space to get into. I put solvent on it And try to brush it with stiff paint brush. I never seem to get it perfectly clean.
...

Here is all the info i can think of.

hodgon hs7.

reloading guy at on target says 5.5 to 6.5 gn. I am at 6 gn. According to speer its 6.9 to 8.9 gn. Something doesnt seem right as that would...

Why am i having failures to extract?

9mm, caste bullets, dillon progressive press.

thanks

Thats how my wifes gun is. jsut slightly oblonged case and it will jam up. not sure when ill be shooting again. but ill try to remember to get back. it shoudl be great. didnt jam up by hand, should...

Made some more, only adjusted the bullet debth for the tumble bullets. cleand and lubed cases. the ones i tried seemd to chamber well

im at the point that i need to do some reading. i get plenty of flair on my cases, more than enough for putting the bullet in. i think ill take some pictures next time i run it.

Dillon square deal b

0 <--- this is my head ^--- here is where all of this is going over my head

Thanks

Some guys on another forum are saying that i need to adjust the dillon press for cast bullets. what do i need to know about crimping?

Hello,

I made 7 reloads to test a few powder amounts.

Did not clean the cases, they were shot once.

Did not lube them (this stuff will be done from now on now that iv got started)

Cast...